![]() When Cisco IOS XR software is configured with both an IPv4 and an IPv6 address, the interface can send and receive data on both IPv4 and IPv6 networks. For example, if GigabitEthernet 0/1/0/1 conflicts with GigabitEthernet 0/2/0/1, then the IPv4 protocol on GigabitEthernet 0/2/0/1 is brought down and IPv4 remains active on GigabitEthernet 0/1/0/1. ![]() If an IP address conflict exists between two interfaces that are active, Cisco IOS XR software brings down the interface according to the configured conflict policy, the default policy being to bring down the higher interface instance. If a location is specified, only the interface entries in the specified location are displayed.Ĭisco IOS XR software allows conflicting IP address entries at the time of configuration. In Cisco IOS XR software, the show ipv4 interface and show ipv6 interface commands include the location node-id keyword. When the scavenge-timer for a neighbor entry expires, the entry is cleared. The ipv6 nd scavenge-timeout command sets the lifetime for neighbor entries in the stale state. If a location is specified, only the neighbor entries in the specified location are displayed. In Cisco IOS XR software, the clear ipv6 neighbors and show ipv6 neighbors commands include the location node-id keyword. The Network Stack feature in the Cisco IOS XR software has the following exceptions:
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |